Dash Kit
#21
Senior Member
Thread Starter
They are pre-molded vacuum formed pieces with 3M adhesive on the back. They arent a roll of vinyl that must be cut to fit, trimmed, glued and heat shrunk.
I opted for the 'real carbon fiber' variety, well see what they look like upon arrival.
I opted for the 'real carbon fiber' variety, well see what they look like upon arrival.
The following users liked this post:
FerdinandF150 (04-17-2016)
#24
Senior Member
I'm sure they come with install instructions, but something I do when I install vinyl is use painters tape to hold it once I have it lined up with markings/holes/seams and then peel a little backing off to get it stuck down and slowly continue that downward. Not sure if that will work in your case or not.
The following users liked this post:
Willard5.0 (05-06-2016)
#26
Senior Member
#28
Senior Member
before
after
I added some 3D carbon fiber look to the 2 side pieces. I always disliked the satin silver . My first attempt at vinyl wrap,so of course I chose pieces with compound curves
#29
This looks really good. I want to do the same or similar. Hate me OEM wood grain look
#30
Senior Member
The Remin kit looks to be good quality.