Cab lights installed! pics!
#23
To the OP.... nice job!
i have installed 4 sets now on different trucks i have owned. I used rubber grommets for each on the holes to run the wiring into the cab, and RTV in addition to the gasket for sealing. I never had ANY issues with leaking into the cab.
I did, however, have some "slight" issues with condensation inside the light housings. Be sure to keep an eye on the rubber o-rings which seal the mounting screw holes at the tops of the light. Mine dried up, and let moisture in. After a couple of days parked inside the garage, it dried up and i replaced with new o-rings.... problem solved!
i have installed 4 sets now on different trucks i have owned. I used rubber grommets for each on the holes to run the wiring into the cab, and RTV in addition to the gasket for sealing. I never had ANY issues with leaking into the cab.
I did, however, have some "slight" issues with condensation inside the light housings. Be sure to keep an eye on the rubber o-rings which seal the mounting screw holes at the tops of the light. Mine dried up, and let moisture in. After a couple of days parked inside the garage, it dried up and i replaced with new o-rings.... problem solved!
The following users liked this post:
Devin4x4 (01-20-2013)
The following users liked this post:
Devin4x4 (01-20-2013)
#25
ok, so again...what are these for?
The following users liked this post:
AreL11 (01-16-2013)
#29
Senior Member
Thread Starter
couple night shots and a few cleaned up! No plans for anymore mods anytime soon! lol finally the way i want it..for now lol
Last edited by Devin4x4; 01-20-2013 at 09:34 PM.