hildrethrj1960

Any information or tips on Borla Exhaust installation...P/N 140291. Thanks

Platinum_Sean

Get a tube of heat resistant silicone, the orange kind. Seal all joints before tightening the clamps for a tight seal.

Also get 2 after-market clamps. 2.5 and 2.75". Where the pipe on the kit joins the OEM one, the OEM clamp will not close enough. I torque mine clean off. You will need another clamp, which is NOT supplied.

Other than that, its a simple install. Click the link in my sig- my first kit had 1 pipe hanger that was off a bit, Borla sent me to new exit tips- great customer service.

I also painted the cross over pipe with a flat black heat paint to hide the pipe. I wish I did that before the install. In the vid below you'll see where and why.

Video: