Anyone have or familar with the Powerboard or Powerboard NX Wireless?
#11
Senior Member
I was wondering about those sensors also. I do not think I would put them on the back doors of the SCREW. I load dogs and grocery's in the back doors so the steps can stay up out of the way.
#12
Senior Member
Thread Starter
Not a bad idea. And with these you could just mount it and pull the magnet if you wanted back doors deactivated. Then put them back if you change your mind
#13
Greetings!
I made that video, and we purposefully put the sensors in the most obvious spots, so they'd show up better on camera (I might not have thought that all the way thru!). You can put them lower, higher, or on the middle pillar.
The newer PowerBoards (NX and regular) do stay down longer when you close the doors. That was based on good feedback from customers.
I've never heard of anyone not wanting them connected to the back door before, but ezTarget is right: it would be really easy with the NX version. Yippee! Extra unintended features.
Thanks for your interest. We appreciate it.
edit: There's a $100 rebate, and it applies to the new PowerBoard NX
I made that video, and we purposefully put the sensors in the most obvious spots, so they'd show up better on camera (I might not have thought that all the way thru!). You can put them lower, higher, or on the middle pillar.
The newer PowerBoards (NX and regular) do stay down longer when you close the doors. That was based on good feedback from customers.
I've never heard of anyone not wanting them connected to the back door before, but ezTarget is right: it would be really easy with the NX version. Yippee! Extra unintended features.
Thanks for your interest. We appreciate it.
edit: There's a $100 rebate, and it applies to the new PowerBoard NX
Last edited by GeoffatBestop; 03-08-2013 at 02:01 PM. Reason: extra chance to sneak in some marketing!
The following users liked this post:
xxxkahunaxxx (04-15-2013)
#16
Senior Member
Thread Starter
#20
Does anyone have experience with Bestop Powerboard or Powerboard NX? I ran across the Powerboard which appears to be a bit less expensive compared to Amp Powerstep. Looking around I found they have an NX version that is wireless so you don't have to tap into your wiring for activation and after installing LED Sill plates this weekend, this actually peaks my interest. So many of those wires are so delicate, I think I'd like to minimize as much as possible having to tap into them.
These things are amazing! People freak out when they see them slide out from under the truck!
They harness into your door ajar wires.
The taps they supply are the best on the market.
There are only four wires you are tapping into.
On my 2013 truck, all wires are found on the passenger loom, easily accessible by removing step plate!
I highly recommend these!!!