2012 plug and play remote start
#1
Member
Thread Starter
2012 plug and play remote start
this may sound dumb but I seriously need help with this. the antenna is ran and everything ready to connect, but i can not find the tpms in my truck or any sort of harness that my remote start module is supposed to plug into. This is supposed to be a 5 min install but i have been in the truck going crazy for about an hour now and cannot find anything.
tried searching but cant find anything that helps. just zoomed in pics of the tpms...still have no clue where it is
tried searching but cant find anything that helps. just zoomed in pics of the tpms...still have no clue where it is
#2
Member
Open the passenger door, look at the end of the dash, remove that panel, look at black box and see hole that matches the remote start wire connector, plug that wire in and replace side panel, now go to dealer and have them activate remote start.
If you got the 100 series like I did then you also have two new keys with an added button, cut those keys and program them to your truck.
Enjoy.
If you got the 100 series like I did then you also have two new keys with an added button, cut those keys and program them to your truck.
Enjoy.
#6
Member
Thread Starter
Right on, hopefully they know what there doing. Pretty small town so im guessing they haven't had much experience with these plug and plays yet. Hopefully i can explain what they have to do to them well enough lol.