Yet another dumb question
 

Having trouble getting a good alignment... 6" rough country lift. All ball joints and bushings and bearings have been replaced where needed. New caster/cander bolts installed today and the front tires still slant in on top. Does anyone make a bracket that would fit between the frame and the upper control arm that would allow caster/cander adjustments on the top side? The bottom is pulled in as far as it can go. The top needs to go out... I think

Can you attach a picture of your set up?

Besides the Rough Country kit, are you running anything else with it?

It should normally line up unless you are cranked higher than 6".

Don't know that the question is dumb at all. However, if you're looking for help for a specific problem, the title of your post ensures very low readership. I would have suggested "Question re: getting alignment with 6" lift" or similar.

Picture as requested
 

https://cimg3.ibsrv.net/gimg/www.f15...b212ad9a7e.jpg

https://cimg4.ibsrv.net/gimg/www.f15...e3c323a56a.jpg