2010 f150 lift kit help
#1
2010 f150 lift kit help
Hello I have a 2010 f150 right now it has a rough county lift kit on and after driving for a while I would like to go a little higher. So when I got the kit I order the 6inch lifted struts instead of the spacer. I order a 2 in rcx leveling kit and installed it on the front also a rcx 1.5 add a leaf but the back sat about 2 inches higher in the back I would like to get it level as possible but can’t seem to figure how to do it the block in the rear is about 5.5in. Also the angles looked not so great in the front.
#2
I tryed to edit the post but couldn’t after the install i go for a test dive and when I made a left turn my traction control would turn on and it would apply the brakes I’m confused why is would do this nothing comes up on a scanner while driving it’s goes on 20mph and up only making left turns
#3
Mark
iTrader: (1)
Pull the spacer out and you should be close to level.. and your cv shaft will love you for it. If you want to go higher install a superlifts 7.5” or 10”
ABS light.. from the looks of all the zip ties you may have pulled the ABS wire out.. you need some slack in those wires to account for when your suspension flex’s
ABS light.. from the looks of all the zip ties you may have pulled the ABS wire out.. you need some slack in those wires to account for when your suspension flex’s
Last edited by techrep; 02-24-2018 at 03:36 PM.
#4
Senior Member
Too much angle on your CV drive shafts. You are asking for premature wear on those CV's and the steering ball joints look close to maxed out. I have the same 6 inch RC lift kit on my truck and my CV drive shafts are near horizontal. It's not recommended to install additional spacers with this lift kit. I agree with the above suggestion, to install a larger lift kit if you want to go higher than 6 inches.
Last edited by Al_Maryland; 03-17-2018 at 12:26 AM.