Nitto Ridge Grappler 35's
#51
Senior Member
#52
Senior Member
Welp.. Got the truck set up.. Looks great. Does rub a little.. Some minor plastic trim should definitely take care of it. It's not bad at all, and poses no real harm to anything. I could live with it if necessary. But here it is... 295/65r20 ridge grapplers on 20x9 fuel Mavericks +20 offset and a 2.25 inch ready lift level.
Curious to see how the width looks at a couple different angles (straight on, 7/8 angle, 3/4 angle, and 5/8 angle
Looks surprisingly low from the photos for having a 2.25" level.
Is it a 2wd?
Last edited by tthibault16; 12-27-2016 at 04:13 PM.
The following 2 users liked this post by tthibault16:
DrewJones87 (03-06-2021),
xrayvzn (09-16-2017)
#54
Mike
#55
Senior Member
how are you liking your setup? I really cant decide between 295/60, 295/65, or 35x11.50's!! I am worried the 295/65's would be too tall, but they fit your 2wd. My '13 4x4 looks like it has tons of room in the wheel wells. Wished I could test fit them all.
#56
Junior Member
295/60R20 Ridge Grapplers on Factory rims
I'm happy with the stance
Loving the new ridge grapplers I didn't go with the 35's as I only have a 2.5" rough country lever kit on. But the 295/60R20 on factory rims give me 33.94" and a good look I can live with.
The following 3 users liked this post by TP_68_XLT:
The following users liked this post:
xrayvzn (09-16-2017)
#58
Senior Member
Any rubbing at all? Can you post some shots showing how they fill out the width of the fenders/flares?
#59
Junior Member
Tire with no Rub
Zero Offset on the factory Rims. Works well.
It's a clean line with no protrusions.
Room to turn front and back.
Gets a bit tight here. Close is not a rub so I am fine with it.
j.digiacomo
Here are a few more pics. I have the PSI at 40 and have no rubbing -full turn to full turn. Oh it's a tight fit but.... Hope these are helpful.
The following users liked this post:
j.digiacomo (01-24-2017)