Frankyh562

Well it's been discussed here for quite some time and have seen it done by few,, and well here it finally is, awesome work by Greg from Desolate Motorsports.. 315x70Rx17 alignment is on point used to have a Ram with a 6" lift and it's nice and all but parking structures were a bitch and it was too much at times IMO, which I why I took this route and I'm glad I did, I love it.

techrep

iTrader: (1)

Do you mean 305/70/17 ?

SteedaGT

iTrader: (2)

2wd? What did you do with the crash bars? Offset of the rims please.

It looks great!

Custom Offsets

Lookin badass!!!

LXCoupe

They look like 17" Method NV's which are 0 offset. I think OP also meant 315/70R-17s which are 34.4x12.4 (same as raptors)

Frankyh562

Yes I forgot the 1 in between but 315x70R17 is the correct tire size

Frankyh562

Yes sir 2wd & 0 offset

SteedaGT

iTrader: (2)

I love the look! Did you spread your crash bars or have to remove them completely?

Frankyh562

Thank you, and I had the crash bars removed bro, you can swap the passenger with drivers and have them reversed but after speaking to the shop that did the install they told me they've tried it and it still hits... barely but they just trim the bar halfway which I'll pass, it's up to the person to be honest , I had to trim the plastic (small amount) against the rear fender wells in the both fronts but believe me when I say you can't even tell, they did an amazing job and it's looks like my truck came from the lot this way.. I've seen videos of guys trimming it themselves and it comes out pretty bad tbh, in this situation dealing with my 50K truck I didn't mind paying for a professional to handle the job.

Frankyh562

����