Terminal ends for amp power connections
#22
Senior Member
Thread Starter
I just have the bare wire going into the amp terminals, however after seeing how far the wire goes into the terminal I went a step further. Just wrapped some electrical tape around the where the coating is stripped to ensure no loose strands can touch anything. Works for me.
#23
Senior Member
Thread Starter
It was a good day to install the ferrules on the power wires for my amp and sub so, that's what I did today. They went together with some trouble but, in the end, they are firmly attached. If nothing else, it will ensure that none of the hairy wires will do a dance between the cables.
#24
#25
Papermaker24
I just joined due to this thread. Last night I ordered several different sizes. Here is a crimper that will work down to 1/0. I'll hopefully find what I am looking for to hook an amp to my factory HU. I have a 2018 f-150 2.7l with Sync3 6 speaker no-amped non Sony. All I need is the wiring that plugs into the radio and the female connector/harness that plugs into that one.
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
FOR-11CK harness will hook you up...
Last edited by papermaker; 06-18-2019 at 03:34 PM.
#26
The set screw will do the crimping for you......at the amp. I have a circuit breaker with set screws for my power. Ground does need an eye and power to the battery as well, nice find.
FOR-11CK harness will hook you up...
https://www.amazon.com/CUTTING-HARNE.../dp/B00D9W3CHY
FOR-11CK harness will hook you up...
https://www.amazon.com/CUTTING-HARNE.../dp/B00D9W3CHY
I ordered the FOR-11CK harness today. Should be here Friday or Saturday.
If you or anyone else needs factory info I can look up most things on Mitchell OnDemand.
#27
Papermaker24
I bought a set of cutters at HF. Had the eyes crimped at work👍🏿