post them sub boxes if u built yer own lets see them
#1
Senior Member
Thread Starter
Join Date: Apr 2012
Location: moncks corner sc
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
post them sub boxes if u built yer own lets see them
sealed enclosers 1 cubic ft airspace
2-10 inch Pioneer TS-W250R
Absolute DBM800 Digital Bass Maximizer
Planet Audio AC1000.2 MOSFET Two-Channel Power Amplifier, 500 Watts x 2
#4
Originally Posted by h00ty
ya those are sweet i shoild have taken more time an designed mine a bit better but i can allways do it again an i prolly will
But my 18 and my T2 12 were by far the loudest! And the 2 P3s 12s in the red and black box were insane as well.
#5
Senior Member
Thread Starter
Join Date: Apr 2012
Location: moncks corner sc
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
those 2 10's hit pretty hard i subdevided the box so there is alot of wasted space thay are at 1 cubic foot of air space an the proccessor helped alot
#6
Originally Posted by h00ty
those 2 10's hit pretty hard i subdevided the box so there is alot of wasted space thay are at 1 cubic foot of air space an the proccessor helped alot
#7
Senior Member
ok so, here's my build.
don't shoot me, but this was for a 2005 Toyota Tacoma. I just, within the last 2 weeks UPGRADED and bought a 2011 F150 SCREW. My old sub fit under the seat, thankfully. That said, I need to route off 3/8 of an inch to give it just a bit more room under there for excursion. If that's not enough, then I'll need to add some washers under the seats to raise them up, I guess. Not ideal, but I'm totally time poor, and building another sub, while sounds fun, doesn't fit into my schedule.
Anyways... here's my build of a 1 cuft Rockford Fosgate 10" P2 sealed sub.
don't shoot me, but this was for a 2005 Toyota Tacoma. I just, within the last 2 weeks UPGRADED and bought a 2011 F150 SCREW. My old sub fit under the seat, thankfully. That said, I need to route off 3/8 of an inch to give it just a bit more room under there for excursion. If that's not enough, then I'll need to add some washers under the seats to raise them up, I guess. Not ideal, but I'm totally time poor, and building another sub, while sounds fun, doesn't fit into my schedule.
Anyways... here's my build of a 1 cuft Rockford Fosgate 10" P2 sealed sub.
Trending Topics
#9
Proudly Canadian
#10
This is in a 2011 Raptor. The seat lift came from LMI Welding. I think it was a 2.5" lift. Easy to install, just make sure you have everything in place before you start tightening any bolts. Its hard to see out of the back window now also. The headrests from the rear seat take up a lot of room. Here is a link... I believe it works for both Scab and Screw.
http://lmiwelding.com/