Need help
#11
Senior Member
Where exactly are the factory sub wires? I managed to get my seat folded down... had to use a wrench because my strap for the release was on the floor behind the seats....
I see the factory ground, and a purple/black wire going into the defroster, but nothing else.
This is a 18' xlt supercab, 302a equipment package. Non b&o system, no stock sub. Does have 8 inch sync 3.
I see the factory ground, and a purple/black wire going into the defroster, but nothing else.
This is a 18' xlt supercab, 302a equipment package. Non b&o system, no stock sub. Does have 8 inch sync 3.
The following users liked this post:
black0utF150 (09-15-2018)
#12
Ohh. Thank you so much, I saw that green tape. So much for all that effort on the damn seat XD
#13
Alright so I got everything hooked up... but no bass.
I tapped into the Violet/Grn for positive and green/white for negative on that plug. My LC2i is sensing signal and turning on. Amp is powered on.
Moving the signal inputs around on the LC2i creates interference which I can hear through the sub.
What am I missing?
I tapped into the Violet/Grn for positive and green/white for negative on that plug. My LC2i is sensing signal and turning on. Amp is powered on.
Moving the signal inputs around on the LC2i creates interference which I can hear through the sub.
What am I missing?
#19
Senior Member
Have any of you had issue running two runs of speed wire along the driver side? Is there plenty of room in there? My speedwire is about 1/2 inch due to the thick outer insulation. Thanks.
#20
I didn't run any. I'm using stock wiring for the speakers, put the crossover blocks in the door right under the handle. I'm also running OEM tweeters in the A pillars - they sound fine to me.