Door panel rubber cap?
#1
Rear door panel rubber cap or bumper?
Where does this go again? Found loose on the floor post rear door panel removal. Didn't happen up front. I know it’s been discussed but I can’t find it. Thanks in advance.
Last edited by noclutch; 11-18-2018 at 08:59 PM.
#4
(TIM) Retired Army 1SG
It goes on the door as a spacer to help keep the panel from rattling I was told. I found one when I had removed my drivers door panel for speaker swap, after I had already replaced the panel. I will have to find exactly where on the door it goes next time I remove the panel. I think the mid to lower rear area though of the door.
#5
passtim - yea that’s what I was thinking they would be for, but for the life of me could find an obvious place it would fit. In my case, none fell out of the front doors though 🤷🏻*♂️
Last edited by noclutch; 11-19-2018 at 03:58 PM.
#6
Anyone figure out where these caps go on the rear door panel .. The rubber cap pictured above popped out when I was removing my rear door panels on my 2018 screw . More specifically when I pulled and unclipped the lower part of the door panel . Almost like the were just sitting behind the panel .
#7
Junior Member
I ran into this same issue on my 2018 screw, too, and found the below post. The rear door panel has a plastic post that the rubber cap apparently goes on top of.
https://www.f150forum.com/f118/budge...2/#post5769234
This is where I installed mine, which seems to be the only possible location:
:
https://www.f150forum.com/f118/budge...2/#post5769234
This is where I installed mine, which seems to be the only possible location:
:
The following users liked this post:
Wyo11Scab (01-12-2021)