When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
The stock positive battery terminal on the 2012 F150 is an interesting piece, and am unsure which post I could/should connect my 4ga (fused) power wire to. The picture attached is the best I could quickly find online.
Am I okay to simply stack my cable's ring terminal on top of one of these two non-fused stock ring terminals and re-lug on top? Or do I have to do something standalone?
I used the lug nearest your index finger. Washer, terminal, washer, nut.
Outstanding, thank you! I had a feeling that was the best bet, I just wasn't sure if it was problematic to "stack" like that. Reading around on the web, it doesn't seem like it's a problem, especially if it's only 2 ring terminals stacked.
@Inspector656 - would you mind also sharing where you mounted your fuse within the engine bay? I was thinking of using self-tapping screws to mount to a section of the passenger side chassis near the battery location.
@Inspector656 - would you mind also sharing where you mounted your fuse within the engine bay? I was thinking of using self-tapping screws to mount to a section of the passenger side chassis near the battery location.
I used industrial strength Velcro to mount it on the inner fender next to the fuse box.
09-22-2017, 11:16 AM
Amp Power Wire @ Battery Terminal Install (?)
