2018 front stake hole pockets
#1
2018 front stake hole pockets
I have a 2018 Lariat SuperCrew 5.5 bed. Can anyone confirm that it still has Front Stake Pockets under the plastic rail covers. I want to cut it out and put some tie downs (DIY Bike rack over BakFlip MX4). Thanks!
#2
Senior Member
You can confirm it by looking inside the bed to see if stake holes are formed into the bed.
The following users liked this post:
szym (06-17-2019)
#4
Ok thanks. Why Ford decides to cover this hole is beyond me. The back one, as you say is perfectly capped and easily accessible. They make the customer drill and cut a brand new truck. I asked 2 Ford dealers if the pocket holes exist and if the measurements are the same as previous years and they both had no clue.
The following users liked this post:
clarkritchie (06-15-2019)
#5
Senior Member
Ford has a router bit specifically for cutting out the cover on the front stake pockets.
The following users liked this post:
szym (06-17-2019)
#7
Senior Member
Trending Topics
#8
Member
Installed an adarac on my 2018 Lariat. Drilled a hole in the centre of the pocket so l could see my exact location, then drilled a hole in each corner. Then used a jig saw to cut the plastic cover using the metal pocket side as a guide.If you don't get the cut line just right, the large size utility knife cuts the plastic pretty easy.
#9
Installed an adarac on my 2018 Lariat. Drilled a hole in the centre of the pocket so l could see my exact location, then drilled a hole in each corner. Then used a jig saw to cut the plastic cover using the metal pocket side as a guide.If you don't get the cut line just right, the large size utility knife cuts the plastic pretty easy.
#10
Member
I believe the measurements are the same but I just used a tape measure to locate the approximate centre of the pocket. Once I knew I was in the right area I drilled the four corner holes which allowed me to insert the jigsaw blade.