Bleeding Brakes...F*%K!!!
#1
Junior Member
Thread Starter
Bleeding Brakes...F*%K!!!
Replaced front pads and calipers my '97 F150. Decided to flush brake system with new fluid. Everything started off great however, I CANNOT GET THE REAR BRAKE BLEEDER VALVES LOOSE! I've tried everything in my toolbox. Even got some Blaster/Penetrating spray.
I've used an open ended 10mm wrench and socket wrench to no avail. I'm at my wits end and don't want to have it towed to a garage.
Anybody have any tips or tricks or any suggestions to loosen these bleeder valves?
TIA
I've used an open ended 10mm wrench and socket wrench to no avail. I'm at my wits end and don't want to have it towed to a garage.
Anybody have any tips or tricks or any suggestions to loosen these bleeder valves?
TIA
#2
Mark
iTrader: (1)
Are they rounded off ? Or just tight ? Rounded off I would try vise gripes and then replaced. Tight .. I would used a boxed end wrench or a six point socket and tap it with a hammer. I believe they are 10mm.
Last edited by techrep; 10-20-2017 at 07:16 AM.
#4
Renaissance Honky
Kroil or PB'laster.
Heat.
Bust 'em off, drill out, use a screw extractor.
Heat.
Bust 'em off, drill out, use a screw extractor.