Truck shaking after test drive!
#1
Member
Thread Starter
Truck shaking after test drive!
I just got my edge evolution cts2 today and I was testing it out, of course. I was driving pretty hard on it testing the 0-60 and 1/4 mile times. Ran great until I got home and put it in reverse to back in my driveway. The whole truck started shaking and there was some rattling. I was able to back into the driveway, which was only about 20 feet. I shut it off and started it back up after about 5 minutes and there was no more shaking. I even drove forward and reverse with it. Is it possible I pushed it too much? I'm sick to my stomach over this!
#2
Mark
iTrader: (1)
return it back to stock then reinstall the tune.
The following users liked this post:
Convin (02-04-2016)
#4
Mark
iTrader: (1)
good to hear... enjoy
#6
Mark
iTrader: (1)
ECM hiccup during tune load ... who knows... the truck needs to re-learn after install..you should drive a normal drive cycle before you start racing it around... if you looked at the DTC codes you probably still had a P1000 DTC = incomplete drive cycle
Last edited by techrep; 02-04-2016 at 11:38 AM.
The following users liked this post:
Convin (02-04-2016)
Trending Topics
#8
Mark
iTrader: (1)
Your Welcome... enjoy the Edge
#9
Member
Thread Starter
Update:
I've been playing with my edge and doing custom settings. The thing is SICK! I know this because I set it back to factory settings after using the edge on extreme for about 5 months. My truck turned into a snail. The edge really does pump up the power!
I've been playing with my edge and doing custom settings. The thing is SICK! I know this because I set it back to factory settings after using the edge on extreme for about 5 months. My truck turned into a snail. The edge really does pump up the power!
#10
Mark
iTrader: (1)
Yep