Swap to Floor Console-16 XLT
I recently completed my swap from bench seat to floor console without issue. Thanks to this incredible site, it was pretty painless and only took an hour. The console I bought came with a wiring harness and both vent trim pieces. I had to purchase the two AC ducts (truck was pre-duct behind the radio which I cut the cap off to allow air flow) and the lower trim piece above the sliding cover. Overall very pleased and excited.
HOWEVER: I can not get power to the rear cigarette outlet and house plug as well as the inside cigarette outlet in console. I switched the double USB with the single USB from previous tray for SYNC purposes and have power to the cigarette outlet next to it. The wiring harness was connected to the plug coming out of the floor. Am I missing a fuse? https://cimg4.ibsrv.net/gimg/www.f15...100e8fd4aa.jpg https://cimg5.ibsrv.net/gimg/www.f15...eded2fb765.jpg |
Possible fit in 2011
Would anyone here know if the full flow through console from a 2015 or later is at all compatible with a 2011?
Please keep in mind I'm not expecting direct bolt in swap. I would expect some degree of fabrication/customization to make it work. Would anyone be able to enlighten this quandary for me? |
Originally Posted by ma-fkn-ugh
(Post 5445564)
Would anyone here know if the full flow through console from a 2015 or later is at all compatible with a 2011?
Please keep in mind I'm not expecting direct bolt in swap. I would expect some degree of fabrication/customization to make it work. Would anyone be able to enlighten this quandary for me? https://cimg7.ibsrv.net/gimg/www.f15...1ac7b6a879.jpg where the shifter was, even hooked the rear vents up to the a/c. https://cimg9.ibsrv.net/gimg/www.f15...e199cf1f76.jpg |
I have a '16 flow through console I will be taking pictures of and putting on sale sometime over the weekend. Came out of a special edition Lariat and I swapped out my console cover, shift knob and boot with it. Black leather now with normal stitching.
|
Originally Posted by truck8lt
(Post 5468137)
why not buy the center console from an 09-13 and the associated trim panels and other parts needed. I did the swap on my 13, made a storage cubby for
https://cimg7.ibsrv.net/gimg/www.f15...1ac7b6a879.jpg where the shifter was, even hooked the rear vents up to the a/c. https://cimg9.ibsrv.net/gimg/www.f15...e199cf1f76.jpg |
Through eBay, prices vary, usually around 178 for both (l&r) as a pair. If the floor kick trim wasn’t included w your console, you’ll need those 2 pieces too, around 48 each.
|
I would like to do the same project and was wondering the same thing 428.....
|
I did this center console swap with a shifter on mine its a single cab
https://cimg0.ibsrv.net/gimg/www.f15...0603a1bf4b.jpg |
I did the swap on my 13. Went from the seat to the console. My dad liked it so much that he wants it done on his 16. Now to just find a console and pieces for it
|
All times are GMT -4. The time now is 11:32 PM. |
© 2024 MH Sub I, LLC dba Internet Brands