Removing fender badges '17 F150 to disassemble and paint
#21
Senior Member
Cool, yeah looks 1000% better.
Did you cover the entire back of the emblem with the foam tape or just a few pieces spread around?
I'm wondering if you can see voids caused by the missing adhesive at extreme angles if you don't cover the entire surface area of the emblem. It would take a lot of trimming with an x-acto blade afterwards.
Did you cover the entire back of the emblem with the foam tape or just a few pieces spread around?
I'm wondering if you can see voids caused by the missing adhesive at extreme angles if you don't cover the entire surface area of the emblem. It would take a lot of trimming with an x-acto blade afterwards.
Im not convinced they are needed at all as the clips seem very strong - they made a loud 'clunk' when I fitted the badges back on!
#22
Senior Member
Damn that blows about the dents... I had some very minor marks on the holes for the clips from pulling the clips out, pulled the aluminum out a tiny bit right at the center of the holes, but no dents using a heat gun when I replaced my emblems.
I just used a plastic trim tool to push the spots back in around the holes, but the emblem covers it up totally.
I just used a plastic trim tool to push the spots back in around the holes, but the emblem covers it up totally.