Wiring for electric exhaust cutout?
#1
Junior Member
Thread Starter
Wiring for electric exhaust cutout?
Adding a electric exhaust cutout. Where is a good place to connect power for the on/off toggle switch? Is there a fuse # that is "key on." Inside the kick panel? Should I use an add a fuse tap?
I read someone using fuse #37 for a light bar. Looks like it is rated at 20A, is that adequate?
Thanks in advance y'all!
I read someone using fuse #37 for a light bar. Looks like it is rated at 20A, is that adequate?
Thanks in advance y'all!
#2
Senior Member
The rated amps should be listed in the instructions. Is the power routed thru a relay?
#3
Junior Member
Thread Starter
direct to the negative post on the battery. Connect the red wire with the 5 Amp fused
wire to a 12 volt key on ignition source such as the accessory side of the fuse block.
The wiring itself has a 7.5 amp fuse. Will take a picture shortly
Red power wire has inline 7.5 amp fuse. Instructions say the small black box is the \"brain"
Last edited by ras_F15.0; 01-14-2020 at 07:54 PM. Reason: Photo added