Installed Ford splash guards front and rear with stainless insert.

Should have went with after market, as these were nothing special, I had to mark them, level them, drill them etc. I was hoping for a more plug and play installation.

Should have went without the insert, since I can only really see the one on the left rear wheel, the other wheels have the tail pipe or running boards in the way.

 

Did the drivers side seat lumbar mod (reducing the amount the seat lumbar presses into your back) on my '17 Scab XT STX and have the cuts and scrapes on my hands to show for it. Can't wait to take it for a test drive today, hopefully it helps reduce the discomfort I've been having with these seats, its been like driving with someone's knee in my back, Lol.

 

Purchased it! 2018 stx with the 2.7 ecoboost

 

Wired in my new Raptor wheel to make the paddles functional.

 

Gotta fill me in on the gauge setup you have going on there!

 

Boost and wideband. Gen 3 Whipple isn’t installed yet...just put those in so they’re there when I have time to put the blower on.

 

Are those just mounted in gauge cups or do they have a new bezel out?

 

They’re electric gauges so I used the small Omni Pods from AM then modified the brackets so they would sit closer to the bezel then fabbed covers for the brackets.

 

fought with wife and installed opt-7 redline triple.

 

Installed Husky Wheel well liners and removed my front lower air dam for testing.

Hope to put on some door sill textured protector tape this weekend if the temps are warm enough.