What did you do to your truck today?
#3841
Senior Member
I did not remove any of them. The center console was unbolted to wrap to the back of the cover and I removed the glove compartment rubber trim.
Just cut the pieces slightly oversized, then line up the bottom and one side. Lay the wrap flat as you work the way to the other side, then push the wrap into the crack between the faux wood and chrome, that's your cut line.Cut with a pen-type utility knife and peel away the excess. One 5' X 1' was enough to do everything and have a screw up or two(depending on the piece).
I made a template for the center console piece to cut out the Sync and handle pieces before laying that piece down, that made it a lot easier.
Just cut the pieces slightly oversized, then line up the bottom and one side. Lay the wrap flat as you work the way to the other side, then push the wrap into the crack between the faux wood and chrome, that's your cut line.Cut with a pen-type utility knife and peel away the excess. One 5' X 1' was enough to do everything and have a screw up or two(depending on the piece).
I made a template for the center console piece to cut out the Sync and handle pieces before laying that piece down, that made it a lot easier.
#3842
Originally Posted by BMack37
Did LED license plate lights today, looks soo much better IMO. Yesterday I did some vinyl carbon fiber to cover the black faux wood that looked terrible.
#3843
Senior Member
Did alot over the weekend, got it Krowned, installed weather tech mats, programmed 3 homelink buttons, created a new code for keyless entry, learned how to properly use the proximity lock/unlock and installed husky front mud guards. Still need to install husky rear liners and rear mud guards but need a day above freezing
Last edited by imhip2; 03-18-2019 at 07:29 AM.
The following users liked this post:
Boostr (03-18-2019)
The following 3 users liked this post by Shane803:
#3848
#3849
Senior Member
These emblems come apart. Just use a small flat tip to break the plastic on the red oval backside, and a drill to drill out the other plastic parts. Paint individually and the reassemble and use some super glue where the plastic you drilled out was. Great You Tube videos on it. Not hard at all actually. Tailgate is easy, I too the front end apart to get to the that one which still only took my 15 minutes.
Here ya go...
Here ya go...
Last edited by Shane803; 03-18-2019 at 03:34 PM.
The following 3 users liked this post by Shane803:
#3850
Senior Member
Trading in my 16 for a 24. Way less electronics to go wrong!
The following 10 users liked this post by Stever39:
Boostr (03-18-2019),
Firerunner (03-18-2019),
Florida Hag (03-18-2019),
johnday in BFE (03-18-2019),
OCMike (03-23-2019),
and 5 others liked this post.