remltr

Obviously you originally swapped out the original headlights for the Anzo's. I am surprised that you took this approach for swapping the bulbs, instead of just pulling the whole assembly out and having more room to work with those clips.

I swapped my headlights with Anzo's and did the led's at the same time. Even then those clips were kind of a B*TCH. I did the 4X4LED mod with the resistors and the ballast and poking holes in the caps and using silicone to seal the holes on the caps after running the ballast extension wires through them.

FirstClassFord

Its kind of a pain to pull the entire assembly off. Figured the wheel well way would be quicker and it was on one side lol just not the other

madmatt83

Without starting a yet another Anzio thread, how are the stock halogens in the Anzos compared to the stock halogens in the factory headlights?

AC_F150

How do these bulbs match up with the LED strip on the Anzo? From the video it appears to be a good match.

Did you replace both the high and low beam bulb? (Assuming there are two bulbs I don't even know that) Do i need to buy 1 or 2 of these? Please guide me cause I really have no clue when it comes to LED lights. I just know I love the look you have with the Anzo and LED.

FirstClassFord

Comparing stock to stock they are almost identical if not identical.

FirstClassFord

As far as matching up it looks like it was meant to be that way. They match up perfect. I think i responded to your other comment on youtube. but yes they are seperate bulbs for high and low beam. High beam is on the bottom. Should be same pair of lights but not 100% sure. i would check before you buy two pairs.

FirstClassFord

If anyone has any questions comment on youtube or here but i reply to youtube faster

FirstClassFord

Heres another night shot