dwenning

Have you been using the forscan spreadsheet from livinitup? The menu is activated via the IPC. On my truck, I was able to activate it with the easy method but if that doesn't work, use the IPC tab on the spreadsheet to tell you which values you need for your specific truck

JAY13

I'll take another look at it. Must have missed that part

doug97gxe

there is a line that doesn't look like its related to it.. i missed it too as well .. the IPC line

DangerousRob

Man i got my remote atart working but want to config the ipc for the menu options and climate options if possible. I looked at the spread sheet its just hard to understand. Can u help me ?

dwenning

There are some good YouTube videos on how to use forscan, I would start with that. I'm not an expert and haven't actually used it in close to a year now... once you've done that, you might be able to use the easy method to set up the menu, I was able to in my truck but it varies.

soaringfalcon

iTrader: (1)

Sorry to revive this thread, but do you know where I can find the full installation PDF for the module, antenna and fob?

dwenning

I actually haven't seen an installation instruction sheet for the F150. Someone shared one earlier in this thread that was for an explorer I believe and it seemed to be about the same. Also, I only installed the module that uses the standard fob (by pressing lock-unlock-lock) so I didn't have an antenna to install or new fobs.

soaringfalcon

iTrader: (1)

I could not find them either, so I used a 2017 F150 instructions to run the wires and place the antenna and then programmed it using the two pictures on the 2nd post. page. Everything worked without an issue. Thank you

truckerhat

I have the menu option now, but remote start still doesn't work. Any ideas what I might have missed or what I could check?

In forscan I set
BCM 726-22-02 xxx1 xxxx xxxx
IPC 720-02-02 xxx Fxxx

I have a 2015 Lariat 500a, so no remote start from the factory

doug97gxe

check the jumper on the module itself .... one option disables remote start.. one option enables it