Raptor shift Paddles on non-Raptor write-up
#652
The pins fit!! They also seem to go into the SCCM without an issue. It's hard to know if there are any issues there until I get everything connected, but no strange resistance or anything.
I'm going to get the steering wheel side connected and then look at C210. No promises I will get everything connected with the time I have, but I will report back when I have something.
Once again, nice work on the pin ID and THANK YOU.
I'm going to get the steering wheel side connected and then look at C210. No promises I will get everything connected with the time I have, but I will report back when I have something.
Once again, nice work on the pin ID and THANK YOU.
The following 2 users liked this post by rts9364:
2016BoostedGreyGoose (08-12-2017),
Freeseframe (08-12-2017)
#653
Senior Member
iTrader: (1)
Ok, so great! I am about to place a large order for the new pin wires. To all with this issues of the pin wires not fitting on the 2017 floor shifter trucks (column also though no case reported yet) please reach out to me for replacements. No cost to you of course. Just pm me.
The following users liked this post:
AggieCOSC06 (08-15-2017)
#658
What is the procedure for replacing the pins? Do i need a special crimper? Solder connection as well? Or should i just send it back and have you modify the harness (2017 F150 console shift)
Warrrn
Warrrn
#659
Senior Member
iTrader: (1)
Warren I already responded to you. If you are at all not comfortable doing the repair with the new pin wires it is absolutely best to ship your harness back to me, and when parts arrive I will not send a repaired harness but a new one with the correct pin wires for the 2017. I would just simply ask everyone to just PLEASE wait until I have the parts in hand and post here that I have the parts. It will be easier to control than in this manner. Thanks.