Power deploy steps
#11
Senior Member
#12
Senior Member
Also the chrome piece may slide out of the end with the end caps off. I believe the actual steps are the same its just one has a thin chrome trim piece slid down the edge.
I have the FX4 and don't like chrome at all. I have plastic-dipped all exterior pieces that were not black or Ruby Red. I bought the AMP black steps for this reason too.
Danny
I have the FX4 and don't like chrome at all. I have plastic-dipped all exterior pieces that were not black or Ruby Red. I bought the AMP black steps for this reason too.
Danny
Last edited by dannytexas; 11-26-2014 at 03:54 PM.
#13
Senior Member
If you look close to the edge you will see a groove running the length of the board. this is where the "C" shaped chrome piece slides in.
I really think if you remove the end cap you can just slide the chrome piece out of the OEM power board and then have the black texture look you see in my step in the picture.
Danny
#14
yeah i saw on AMPs website how you could add the chrome piece later and it just slid on. so i'm hoping if it does come with it that it is easily removed or i'll go the plastidip/paint route
#16
I ordered a Platinum that comes with power running boards. I just hope they are nice as the AMP ones that I now have. The AMPS seem to deploy lower making them more useful and the light is nice also.
#18
http://youtu.be/qdQWPxFkOgk
Guys check out this video.
Powered Running step on Platinum @6:15
Guys check out this video.
Powered Running step on Platinum @6:15
Last edited by 007TRUCK; 11-28-2014 at 10:52 AM.
The following users liked this post:
graysailor (11-29-2014)
#19
Senior Member
If you look close to the edge you will see a groove running the length of the board. this is where the "C" shaped chrome piece slides in.
I really think if you remove the end cap you can just slide the chrome piece out of the OEM power board and then have the black texture look you see in my step in the picture.
Danny