Need help wiring adding limited door still to a 2016 platinum
#1
Senior Member
Thread Starter
Need help wiring adding limited door still to a 2016 platinum
Need some help:
I found some 2016 Limited door sill that light up. i want to add them to my 16 Platinum. i need some wiring information on connecting these the limited door sill has a wire connector. i pull up the platinum door sill and was looking for the other connector i figure this might a plug and play but have not locate the other end on the platinum harness. i pull off some of the black tape about half but still have not seen. anyone have the wiring print on the limited and platinum. to see if that wire can be add from the fuse box or it just buried somewhere in the platinum harness.
any info thanks
I found some 2016 Limited door sill that light up. i want to add them to my 16 Platinum. i need some wiring information on connecting these the limited door sill has a wire connector. i pull up the platinum door sill and was looking for the other connector i figure this might a plug and play but have not locate the other end on the platinum harness. i pull off some of the black tape about half but still have not seen. anyone have the wiring print on the limited and platinum. to see if that wire can be add from the fuse box or it just buried somewhere in the platinum harness.
any info thanks
Last edited by AtlasF150; 10-14-2017 at 11:19 PM.
The following users liked this post:
AtlasF150 (11-01-2017)
#4
Senior Member
Thread Starter
Looking for more information when i pulled up the door sill on the platinum there about 6 Voilet wires.
i also a looked at the fusebox next to the glovebox there a couple of connector that are plug into this. some have Voilet wires. can i connected to these? im wanting to set these up like a limited. (im assuming these come on when the door is open and go out like the dome light) let me know how they work.
Im trying to find someone that has a Limited and takes pictures of the wires and where they go to the fuse box or connectors.
#5
Ford seems to have wiring harnesses based on trim level. You would want to tap one of those violet wires for the power. It's sourced from the BCM on pin 26. The BCM is in the passenger footwell. I would use a volt meter to double check the voltage and when the circuit is powered.
#6
Senior Member
The diagram shows the connectors to be C3250(RH) & C3251(LH). You could get the connector pigtails to match and tap into the harness 14A005 which runs under the sill plate. The wiring diagram also shows the violet wire also powers up the lights on the third high mount brake light. Attached are the connector views and the harness locations.