Nirvanamike06

I bought some new floormats for my truck a couple weeks ago. I did alot of reading and it seemed like i found a majority of people more happy with husky over weathertech. They are very nice but it does bug me how poor the drivers floormat fits. There is a pretty big gap, a finger or 2, between the floor mat and the console. The passenger side fits perfect. The back is the full coverage and it fits pretty close to perfect. It had a wrinkle where it seems like it was to wide but it looks like it will flatten out over time and once it heats up some.

I don't know if there's a way to take the studs up on the drivers side to make it fit correctly but unless it does it won't fit right. Just my 2 cents. I may try some weathertech eventually.

bcb97

Did you put it out in the sunlight for a while to let it flatten out? I bought maxliner mats and they fit great. Are thicker too than weathertec. I’ve never had husky’s so I can’t compare to them. If you end up returning the huskys, check out maxliners.

lomax

If you get out Denver way let me know. I would be happy to trade you my Weathertech's for your Husky's .

After ordering them and installing them and a while later, yep my fault, The WeatherTech liners seem hard and slick to me. More plastic like. The Husky mats seem rougher and not slick. More rubber like.

If I had to do it again I would go with the Husky ones. My weathertech's do fit good however.

Fatmattyd

This isn't really helpful... those fit **way** better than the weathertech's I had in my 2010. My weathertechs were off by inches. 2" in places. And they weren't helpful at all after I contacted them about it. I should have returned them.

I ended up going with the Husky's in my 2015 and am much happier with the fit.

icecoldak

My huskys fit beautifully in my 2018, front and back

Lux194

Mine fit perfectly in my 2015 and I plan on moving them to my 2018. Have you tried sliding the posts over a bit? There’s some wiggle room. Try grabbing the posts and moving them over a bit.

Sandpic

What helped mine was I heated them with a heat gun and put weight on them so they would cool in place and that made a big difference.

ManMountainDean

This ^

goathead

My x-act Husky driver side needed to be massaged into place the first time to engage the alignment "*****". After that first time, they fit x-act.

tinner1

iTrader: (7)

I also had the wrinkle in the back, from the liner being folded up in the box which will go away. Now it lays perfectly flat. The fronts also fits perfect.