How to: Swap for OEM LED Taillights
#715
So I am completely new at wiring and making harnesses. Judging by what I have read, wiring both harnesses to match the "Passenger Side" diagram shown here should work for both sides correct? I am excited to try this, but just wanted to make sure I have a good understanding before I screw something up. Thanks again to everyone for the help and especially the OP!
The following users liked this post:
08drenalin (02-20-2020)
#718
Senior Member
So I am completely new at wiring and making harnesses. Judging by what I have read, wiring both harnesses to match the "Passenger Side" diagram shown here should work for both sides correct? I am excited to try this, but just wanted to make sure I have a good understanding before I screw something up. Thanks again to everyone for the help and especially the OP!
The only difference is an extra ground wire, but that won't do anything on the driver-side. In fact, I don't even know if that ground wire going to the #9 pin is even needed on the passenger-side. I had my harnesses accidentally on the wrong side for a few months and both worked fine.
The following 2 users liked this post by Phrozone:
08drenalin (02-20-2020),
mbrick (03-16-2018)
#720
About ready to get this done, taillights are on their way.
I have the harness with the morimoto resistor on it that I bought before we knew we could Forscan this.
Is it as simple as removing the morimoto resistor and plugging in the lights?
I have the harness with the morimoto resistor on it that I bought before we knew we could Forscan this.
Is it as simple as removing the morimoto resistor and plugging in the lights?