FORScan - software to enable/disable features in your truck
#1551
Senior Member
I am having an issue with forscan not writing. I get to 50% and it says service interrupted. I upgraded to 2.3.3. that didn't fix it. I am close to the end of my extended license ID that matters. Any thoughts?
#1552
The Source
What are you trying to write? Your ignition needs to be ON the entire time, but engine NOT running.
#1556
The FORScan Guy
Thread Starter
I had it stall out while writing before and it continued to do that so I hit the button to clear DTCs even though no DTCs were showing and then it wrote fine. Might not work for you but worth a try.
#1557
Senior Member
That is probably it. I know with IDS they clear the DTCs and I have some due to the fog light DRLs and the bulb out warning disabled.
#1558
Senior Member
I enabled remote start in the BCM already and I am working on getting the remote start options to appear in the IC. I have a few hex values I was going to try. On the '15+ trucks what is the values you guys use to enable remote start in the IC? I would be willing to bet that the '15+ trucks are the same as the 09-14 trucks where the remote start is built into the trucks.
#1559
Senior Member
I got that part down.
I enabled remote start in the BCM already and I am working on getting the remote start options to appear in the IC. I have a few hex values I was going to try. On the '15+ trucks what is the values you guys use to enable remote start in the IC? I would be willing to bet that the '15+ trucks are the same as the 09-14 trucks where the remote start is built into the trucks.
I enabled remote start in the BCM already and I am working on getting the remote start options to appear in the IC. I have a few hex values I was going to try. On the '15+ trucks what is the values you guys use to enable remote start in the IC? I would be willing to bet that the '15+ trucks are the same as the 09-14 trucks where the remote start is built into the trucks.
#1560
Senior Member
Yes, was a little nervous after finally getting them working. I took out the magic fuse(doesn't blow if it's not in)started to fight with the plug but seeing that I was in and out under the dash at 330lbs 6'2" for a good hour in 86 temp 65% humidity I took your advice and just cut the grey wire.
Put in my jumper I think I used 14 gauge folded over some on the end to get a good tight fit. Then taped it all up and clicked the module in.
As of now all is working good. I'll test it on my dirt road later,its so bad you bounce right off the road. See if it shakes loose.
Put in my jumper I think I used 14 gauge folded over some on the end to get a good tight fit. Then taped it all up and clicked the module in.
As of now all is working good. I'll test it on my dirt road later,its so bad you bounce right off the road. See if it shakes loose.