Livnitup

Yes, but you don't have lane keeping system in settings. The settings in the spreadsheet are from the perspective of my trim package that should have all the options; the 4DE0 setting has both lane keeping & daytime lights but if you don't have lane keeping then your setting would be the one to use.

cyph3r

This guy can help you, he helped me upgrade from 4.2" to 8" with Nav.

Chris6272

I liked that I could push the center button on the overhead console and not have all my courtesy lights come on when I open the doors. What I didn't like, especially when I was getting out at my hunting spot, was the bright back cab light coming on every time I open my doors. I enabled dark mode,, which took care of this, but I miss the puddle lamps now. Is it possible to just disable the back cab light,when I open my doors, and keep the puddle lights? I like that I can turn on my back cab light from the dash switch, which is all that I want but I do want the puddle lamps back.

TexasFording

iTrader: (14)

remove the bulbs in the cab and disable dark mode?

Livnitup

Spent about 3 hours testing BCM today looking for settings for headlamps/fogs/puddle lights/spot lights. Found nothing for them but found the following:

BCM Module:
726-31-01 xxx1 xxxx xxxx Ambient lighting disabled
726-31-01 xxx2 xxxx xxxx Ambient lighting enabled

726-46-02 xxxx xxx0 xxxx Parking Aid sensors disabled? (Message on cluster "Check Park Aid", Active Park Assist disabled, no audible alerts in reverse with obstruction present
726-46-02 xxxx xxx1 xxxx Parking Aid sensors enabled

726-28-01 xxxx xxxx x0xx Stop/Rear lamp outage on? (Didn't get fast flash but stop/rear lamp remained fully lit) - need more testing with this one
726-28-01 xxxx xxxx x4xx Stop/Rear lamp outage off

Livnitup

One thing I did learn today is that trim packages that don't have spot lights, fogs, puddle lamps either already have the BCM setting set to enabled for these OR there is no option to disable these. I had 3 VIN's as-built info of trucks that didn't have one or more of these lights side by side along with my own as-built settings in a spreadsheet and I tried every difference

f150Drew

Thanks for all the great information using FORSCAN. Got my device and license and was able to remove the double honk, fake engine noise, but when trying to add the temp readings for transmission/engine (Using the PIDs) they are not showing up on my dash screen. Anyone else experiencing this issue?

Texrep

Are you referring the plain English settings? I didn't use them I put in the data for the address
IPC 720-07-01 XXXX-XX(5)X-XXX

Just change the data where the (5) is to 5 and hit write then hit OK on the checksum message after.

f150Drew

Thanks, I will give it a try tonight and report back.

Livnitup

If it doesn't work for you, you may need more than just the change of the "5". If it doesn't work, write down your values for that address and post them here later so we can hook you up.