sigma pi

On the push on part or the threads?

MAK Performance

On the threaded parts. The Push to Connect fittings once they click in they should not leak.

Commander316

if you have the braided lines no, do what MAK says.. if you had the standard rubber ends i would use hose clamps

Romark

I received my UPR catch can yesterday and began looking over the install. No instructions were included but after looking at some install videos, I think I can figure it out. I am disappointed at the mounting method of the can. Its just hanging from the plastic fan shroud and resting against the fan supports. I may modify the mounting bracket with a slight bend then mount it in a more ridged location like the coolant overflow tank mounting bolt. That looks to be more secure than the thin plastic. Anyone else run into this?

sigma pi

I have the push to connect, and I think that is where it is leaking from. :/

Ill try pushing harder. Thank you!

Romark

Question. Once pushed into place, how are the fittings on the UPR kit released in order to remove the hose. I can't seem to figure it out.

Commander316

here's a picture of UPR cans:

far left is Mega
to the right is dual valve
to the right is single valve
far right is standard

nix150

Just thought I'd share. This was drained a little over 1600 miles.

papa tiger

Mine is drained around 1000 miles with about the same outcome + much more water in colder damper months.

MAK Performance

On Sale for the Holiday Weekend....

http://www.makperformance.com/2015-E...tem_p_431.html