Adding Lane assist to a 502A
#141
What do you have for Forscan programming? He mentioned 2 areas, but looking at the IPC I found these 2 in the spreadsheet:
720-01-02 xxxx *xxx Collision Warning & Fog Lamp Indicator: 5=Coll Warning enabled & fog lamp indicator enabled, 4=Coll warning enabled & fog lamp indicator disabled
720-01-02 xxxx 1xxx Collision Warning & Cruise Control disabled
And nothing in the PSCM.
720-01-02 xxxx *xxx Collision Warning & Fog Lamp Indicator: 5=Coll Warning enabled & fog lamp indicator enabled, 4=Coll warning enabled & fog lamp indicator disabled
720-01-02 xxxx 1xxx Collision Warning & Cruise Control disabled
And nothing in the PSCM.
#142
Senior Member
iTrader: (4)
What do you have for Forscan programming? He mentioned 2 areas, but looking at the IPC I found these 2 in the spreadsheet:
720-01-02 xxxx *xxx Collision Warning & Fog Lamp Indicator: 5=Coll Warning enabled & fog lamp indicator enabled, 4=Coll warning enabled & fog lamp indicator disabled
720-01-02 xxxx 1xxx Collision Warning & Cruise Control disabled
And nothing in the PSCM.
720-01-02 xxxx *xxx Collision Warning & Fog Lamp Indicator: 5=Coll Warning enabled & fog lamp indicator enabled, 4=Coll warning enabled & fog lamp indicator disabled
720-01-02 xxxx 1xxx Collision Warning & Cruise Control disabled
And nothing in the PSCM.
#144
Senior Member
iTrader: (4)
I went ahead and installed the new mirror tonight. Took about 5 minutes, but be very careful that you have a firm grip on the mirror. It comes off quick when it goes and there is a lot of wiring around there and defrost wires attached to the windshield.
From reading, connecting Pin 9 to ground turns the system off, so in theory, with that pin pulled it should always be on. Once I get the Forscan changes, I will try it out and test that theory. Then when I get my switch in from Amazon I should be able to turn it off when I want to.
Here is the removal video from earlier in the thread.
From reading, connecting Pin 9 to ground turns the system off, so in theory, with that pin pulled it should always be on. Once I get the Forscan changes, I will try it out and test that theory. Then when I get my switch in from Amazon I should be able to turn it off when I want to.
Here is the removal video from earlier in the thread.
#147
Senior Member
iTrader: (4)
The settings in the IPC are there.
#148
Senior Member
iTrader: (4)
Grounded the pin tonight. Still no icon. Thinking this may require the console harness. I have that, but have not installed yet. Thoughts?
Last edited by storkpkp; 09-12-2017 at 10:31 PM.
#149
I don't understand what the harness buys you. The only wires for the feature are to ground the trigger. It's worth a shot I guess but I would be looking at the mirror itself and the Forscan programming.
My mirror shows up Friday hopefully then I can work on it too.
My mirror shows up Friday hopefully then I can work on it too.
#150
The FORScan Guy
The dash icon isn't going to popup until the calibration procedure is carried out successfully either if memory serves me correctly. I could run the procedure again tomorrow and verify this if you need.