Adding Hill Descent Control to non-FX4 trucks
The following users liked this post:
Livnitup (11-01-2016)
#13
I wonder if this can be added to Trucks with the 3.5 NA engine which do not have the SelectShift mode?
I'm thinking that it may not because the FX4 is not offered with the 3.5 non-turbo engine, I hope I'm wrong.
Now who will be the first to try?
I'm thinking that it may not because the FX4 is not offered with the 3.5 non-turbo engine, I hope I'm wrong.
Now who will be the first to try?
#14
The switch I have now has like rounded corners instead of cut corners so that's what's preventing it from sitting in flush. The left side of my current switch isn't seating in the cutout because of this (pics of current switch below). I now have 2 switches on order: 1 from Fordparts.com and 1 from Tasca so I'll confirm which is best upon arrival.
The following users liked this post:
Slammed0 (04-11-2020)
#16
The FORScan Guy
Thread Starter
#17
Senior Member
Slightly off topic but it goes along my next question. If i wanted to move my 360 camera switch to the left group are the wires long enough and same mounting? It really is an arms reach to hit the 360 button and i would rather have it on the left.
#18
The FORScan Guy
Thread Starter
The wires are plenty long enough to swap button locations and the cutouts looked very similar to me but I didn't try it myself. I'd definitely try it if that's what you're looking to do.
The following users liked this post:
Madcap57 (11-02-2016)
#19
And now I don't need to worry about adding FX4 to my build. Thanks op!
#20
Senior Member