Adding 10-way power seats to XL
#11
Super Member
iTrader: (1)
Good information curious to see who it works out too.
I far as I can tell there is no difference between the "bench" and "captain" seats. I am going to try to figure out the seat heaters to get them to work but plan on moving my vinyl seat covers from the XL over to the XLT seats.
The main reason I bought an XL was vinyl seats and floors. I hate cloth!
The main reason I bought an XL was vinyl seats and floors. I hate cloth!
#14
I got the 2 seats in my shopping cart. The seller is even including 2 extra harnesses to deliver 12v/negative from another source if my floor harness does no power the seats. Any updates on your progress?
#15
Per the wiring diagrams I will search for power at C265. The fuses exist in the fuse box so I am assuming I will need to grab the power for both seats at C265 and run it to each seat.
I have attached all relevant wiring diagrams and photo of a 10 way power sear C311 and photo of a XL C312 stock.
More to follow as I dig deeper...
#17
Wow, I am in the minority, I guess. I would have preferred that my XLT with manual seats. I hate how slow the power seats are, especially when I want to lean back and take a quick nap.
The following users liked this post:
CraigSK (01-27-2021)
#18
The following users liked this post:
Seether1356 (01-01-2020)
#19
Did some research today with my new seats that I have received. The yellow-red cable shown in photo is actual YE-VT to terminal #3 on C311 (driver) & C312 (passenger) which is part of the air bag system.
Per the wiring diagrams I will search for power at C265. The fuses exist in the fuse box so I am assuming I will need to grab the power for both seats at C265 and run it to each seat.
I have attached all relevant wiring diagrams and photo of a 10 way power sear C311 and photo of a XL C312 stock.
More to follow as I dig deeper...
Per the wiring diagrams I will search for power at C265. The fuses exist in the fuse box so I am assuming I will need to grab the power for both seats at C265 and run it to each seat.
I have attached all relevant wiring diagrams and photo of a 10 way power sear C311 and photo of a XL C312 stock.
More to follow as I dig deeper...
Any additional information? have you installed them yet?
#20
Not yet. had Deviated septum surgery last week out June and has prevented from doing much work.
Just tested the seats in the garage with a 12V power supply yesterday. Wanted to make sure all the functions worked before they are installed. Everything checked out alright.
also, have a baby on the way so juggle lots of projects.
Just tested the seats in the garage with a 12V power supply yesterday. Wanted to make sure all the functions worked before they are installed. Everything checked out alright.
also, have a baby on the way so juggle lots of projects.