I keep laughing at all the posts mentioning "passenger detection". If I am going to run over my passenger I have way bigger problems. Oh well they will pick up it is pedestrian detection.

 

You noticed it to, I been getting a tickle out of it also.. But it’s all good. God bless to you brothers and sisters.

 

Finally have accumulated all of the parts to add ACC to my 2017 Lariat 502A. Time to join the club. Guess what I'm doing this weekend?

 

Awesome bro if you run into a snag, just ask we we’ll get you there. This is the best mod.

 

I physically tapped and soldered them.

 

Do you have the wiring diagram for it so I know which wires to tap?

 

I should have some answers by the end of the weekend about getting ACC w/stop & go working on a pre-2018 truck. I only mention this because if someone is about to pull the trigger on buying a 2015-2017 CCM, you may want to wait if it turns out that a 2018 CCM is all that's needed for ACC w/stop & go. I'm going to put 2018 firmware on my CCM this weekend and attempt to get it working because I already have a 2018 IPC installed in my truck right now. If the '18 CCM firmware alone isn't enough to get it working then I'll try '18 firmware on ABS module as well and give it a go.

Hopefully I'll be able to post some results on Sunday...

Edit: If I can get stop & go working then I'll be buying the CADSIII unit also and will attempt to wire that up also for the pedestrian detection.

 

My wallet can't handle this working.... please let it NOT work.

 

If we can get ACC Stop & Go working along with the Lane Keeping System, we're one step closer to taking a nap on a long drive. Now if we could just get that pesky message about keeping hands on the wheel disabled, we'd be golden!

 

Oh please fiqure that one out. My hands are on the wheel.