When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
If I set my abs 760-03-01 to 7XXX, then I get the same TCCM DTC in ABS. If I set it to 3XXX it goes away.
My IPC error came from when I added the Temps above my Trans and Engine Gauges using 720-07-01 set to 8409 8E50 60FA from the spreadsheet. I already had to set one bit here for my Trailer Brake and then when i changed this it threw a DTC.
Change the 8 in the 8E50 to 0 and the DTC should go away.... that is the bit for the 4x4 off road screen
Ok, I had to leave the first 4 bits alone and just set XXXX OE5X XX to get the temp gauges and the trailer brake module to work on mine with no DTCs. My whole line looks like this...
720-07-01 0401 0E50 60F2
Last edited by storkpkp; Aug 22, 2017 at 10:13 PM.
Guys, here's a breakdown of 720-07-01 xxxx x*xx xxxx below. Both the 6th & 7th bit in this address need to be set correctly for the temps to display. The 6th bit controls: Trailer Brake Controller, Gauge Selection (turbo gauge), Temps (enabled/disabled). The 7th bit with the "5" specifies that both the trans & engine temps will display. Here's a breakdown in binary that may help:
I'm posting this because of a pm with Storkpkp and I'm not sure without reading back whether this bit caused any confusion here with the DTC but it shouldn't have anything to do with ACC working without a DTC.
Last edited by Livnitup; Aug 22, 2017 at 10:56 PM.
Yeah, I don't think that was the bit causing the issues. There was some question as to whether the 5th bit was the issue. For some, setting that to 0 cleared the DTC. For me, I just left the first 5 bits from my as built. Changed the 6th E for the trailer brake, and the 7th to 5 to display the temps. That cleared my DTC
I was Just curious if anyone had luck adding this to a 2016 xlt 302a 2.7? Ive been trying to find the bumper harness pinout where it connects to the main next to the head light.
I was getting it on IPC only.... WAS is the key word here.
I compared my IPC data with the data @thematrixhazuneo was nice enough to offer and fixed my issue.
What I found was that I had the Off-road Power Distribution screen enabled & he didn't.... The bit code I had was 720-07-01-8401-8xxx while the bit code he had was720-07-01-8401-0xxx
Once I changed my bit to 0 I no longer have ANY DTC's in my IPC
I would have never thought that screen would cause the issue, but it makes since... the TCCM was looking for off-road data that the truck couldn't give it
So you're a 4x2? I am a 4x4 so I guess I need the 8 in there
EDIT: actually I need E based on Livn's post above.
I was Just curious if anyone had luck adding this to a 2016 xlt 302a 2.7? Ive been trying to find the bumper harness pinout where it connects to the main next to the head light.
working on my XLT. How many wires do you have at the connector(truck side, where the fog/bov/grille harness connects to)
