So I just installed everything for ACC today and for scan will not recognize the CCM. I've been reading and was told by livinitup that it could be that it's not getting any power. I have a 2017 302A. Can anyone help me with getting power to the module? I would really love to start using this feature.

Thank you

 

How will I know if it's the "D" version? I actually got mine from a very generous member on the forum so I didn't have to order it. The number I have on mine is FL3T-9G768-AH.

 

The "D" version is the latest part #.

The # you have posted is not the actual part #. You could try calling your local dealer and ask them to cross reference that # to the actual part #. Be sure to tell them you want the original part # that the # you posted converts to - not the most current part #.

 

I drove over the plate again today, this time there was a car next to me , but there was not the other day.


Maybe I have my sensor to low?

 

Yeah, I'd re-check that it's perpendicular to the ground on a level surface and then do the calibration again.

 

Guys, can someone help him with where power needs to be tapped? I'm pretty sure I read the power wire dead-ends at an inline connector and some guys ran a wire from Battery Junction Box to it before the inline but couldn't find it when I did a quick search.

 

I've attached the document I made for 2015-16. Have not validated for 2017 but should be the same.

 

I got my power (2015 laraiat 501a) from the upper damper harness, which is just below the hood release latch latch

 

Same here

 

Thank you! I've converted that doc to a pdf, uploaded to my google drive and linked to it in my FORScan tutorials under "Helpful Links"