2019 Limited rear bumper
#251
TOTM Sept. '18
iTrader: (1)
I received the Raptor rear section from MBPR on Friday and laid out the whole system on the garage floor today. The middle section will need to be cut for length, then welded. I'm still waiting for some hanger brackets and the bumper corner brackets.
Mike
Mike
The following 2 users liked this post by OCMike:
johnday in BFE (03-23-2019),
sddesigns (03-23-2019)
#252
Doesn't matter!
The following users liked this post:
OCMike (03-23-2019)
#253
TOTM Sept. '18
iTrader: (1)
#255
'19 Lariat 3.5
Got my Raptor downpipes coming today, Corsa catback is ordered, waiting for shipment. Going to order the Corsa X-pipe in a week or 2, then should have everything for the bumper swap and exhaust setup. Except for the truck it's all going to bolt on to.
If anyone has the part# for the hex bolts that are needed for the end brackets, thatd be awesome!
If anyone has the part# for the hex bolts that are needed for the end brackets, thatd be awesome!
#256
what’s up guys I’m new to the forums. I been wanting to do this mod since the 2019 limited was announced. I have everything except for the right side exhaust hanger (HL3Z-5260-B) it’s on back order at all fords. I heard ford is reviewing the part. If anyone has a lead on one. I’d appreciate it. Thanks
#257
Holes for exhaust hangers
I’ve got a 17-no holes and will be drilling them out this weekend. Several have said on this thread thst the holes are larger to allow for adjustments. If anyone with the stock hitch equipped with the holes could share a picture and give a diameter of those. Would be a great help.
#259
Yes, I have everything needed to complete this on Saturday along with two 3x 9x 3/8 exhaust hanger rods which I’ll be heating, bending and welding around the exhaust pipe. got the part #’s from Kevin Tnx- again and thank you for the reply
Last edited by Ridgebacks; 03-25-2019 at 08:57 PM.
#260
'19 Lariat 3.5
Do you have the part# for the hex head bolts for the bumper end brackets?