2016 F150 XLT Dome light wiring diagram
#2
Senior Member
Hope this works. Not sure if this will meet your needs for when you want 12v. Believe you'll want to run off the key switch "on / run position. Perhaps in luck. Here's a similar discussion and a better quality pic (scroll down to the pdf). Good luck. https://www.f150forum.com/f118/need-...onsole-390476/
Last edited by bamashooter; 01-30-2020 at 03:59 PM.
The following users liked this post:
MechatronX (01-31-2020)
#3
Thank you!
Thanks alot the post you referred me too had exactly what I needed. I used VLN04 for 12v and GD348 for the ground. It's a bit of a pain to tap into these tiny wires but results are clean, will work great for a dash cam or radar detector like I did.
The following users liked this post:
bamashooter (02-01-2020)
#4
Senior Member
You bet. Clean installs on about everything is the only way to roll.
#5
It’s easier to tap power from the exterior 3rd brake light, fish the wire back into the cab, then route new wire above rear window into the B pillow. Pull the door rail cap out, and run new wire to lite your new add-on lightings.