Moose08

Completely**** OK i got these / http://www.jegs.com/i/BBK/129/35160/10002/-1 and im looking to see if these will fit http://www.jegs.com/i/Flowtech/387/53609/10002/-1 the old ones that bolt up to the headers are all rusted and leaking hardcore... but i cant find any for my truck so i found those and if they would bolt up i could bend the pipe to work... i was going to get direct oem replacement but i cant find it let alone it has 4 converters!!!! which isnt going to be cheap so i was going to get some collecters and run my own pipe and throw 2 high flow cats on there. Im so lost ive never seen a set up like mine. Truck is 1997 f150 5.4L ext cab

heres a high detailed drawing of what i have and what im trying to do

Moose08

No one know if thatll fit or where i can get ones that do

Buck

dude personally, I would just buy the two hi flow cats and take it all to a shop and have them do it.

whitecrystal1

Why don't you just go with long tube headers instead? The goal your working too is the setup I have on mine. I had it installed but it was is bolt on kit and fits and looks great.

Moose08

I really dont like having shops do work on my truck always liked doing it myself cuz i kno its done right, but i did check it out and all the shops i looked at said they cant bend SS or cant guarantee it woultn crease. Ive always dont cat back ehaust with ss no problems bending it with sand and torch. it was never a problem as far as custom fab goes, i just need to find something to fit initally on the header so i can go to work.


Well i couldnt get long tubes for mine the 1997 underbody unless i got them custom made.Every Y pipe i find only boltd up to your typical 3 bc pattern.

Moose08

Im going to go ahead and get the mustang ones worst comes to worst out 40 bucks.

Buck

More power to ya then brother I was under the impression u were wanting a whole bolt on pre bent set up deal. But since u have the resources to bend the pipe your self then right on! I wish I could do it, but unfortunately living in an apartment has its restrictions

Moose08

ooo nope just the hook ups,im slowly getting movment in my arm so can do my own stuff again, ah that sucks id die with out my garage.

Moose08

well these http://www.jegs.com/i/Flowtech/387/53609/10002/-1http://www.jegs.com/i/Flowtech/387/53609/10002/-1 fit perfect to my bbk headers as well as the stock headers, so if anyone is looking for starter tubes to do custom exhaust those will fit a 97-03 f150 for sure, just letting ya kno

FOMOCO466

I want headers like that so bad for mine I can taste it, lol
I want ceramic coated headers
2 hi flow cats
dual magnaflow mufflers
3 in mandrell bent tubes
3 1/2 stainless tips
for 150.00 lol I know come back down to earth, lol