mopete1

Ive seen threads about this but they dont answer all of my questions

i have a 89 f150 5.0l 2wd efi, i am getting a 5 speed not sure if its the zf or the m5od but im getting it with the tranny tunnel floorboard, the clutch pedal assembly and all hydraulic lines, other than the clutch and pressure plate/flywheel what else is needed to make it right

do i need to get a different starter, transmission crossmember, computer???
thanks for the help, Ian

94Bronc

your stock trans shouldnt be electric so your computer is fine, you may need a new crossmember not positive. i imagine your starter is ok. got a master/slave?

mopete1

Yeah, the guy im getting it from said it has the slave on the side of the tranny and he got the master and all hydraulic lines and pedal assembly

thanks for your input

bobkyle2

you will probably need a drive shaft and i dont really know much about fords.. but on a chevy you also have to have a piolot bearing in the end of the crankshaft..

bobkyle2

and im pretty sure you have to change the brake pedal too

mopete1

Thanks for you help! i know about the pilot bushing, and im pretty sure (98%) that the drive-shafts are the same if the trannys are coming from the same model f150 but im not totally sure, i should be doing the swap in the next week or so, i will update if you care to know