question for the guys whi have 4-6" lifts
#1
Off road rebel
Thread Starter
question for the guys whi have 4-6" lifts
I have the ttb up front and one of the ttb drop brackets looks like I need to drill a hole in my crossmember is this right? Or does the bracket just get supported by the one bolt on the crossmember and the one bolt for the ttb pivot point?
#6
Senior Member
The instructions for the bed's kit say you drill two 9/16 holes for the tab on that drop bracket, I found that here,
http://bds-suspension.com/product-instructions
I searched the part number 507h for the 6" kit
Trending Topics
#8
Senior Member
#9
Off road rebel
Thread Starter
So I thought everything was finished but when Im backing out the driveway, my steering wheel turned about 1/4 turn so I stopped to look and my front tires are pointed like. /-\ ...as soon as I put it drive and move forward I feel a very slight pop then everything looks straight again.. what would that be?
#10
Senior Member
So I thought everything was finished but when Im backing out the driveway, my steering wheel turned about 1/4 turn so I stopped to look and my front tires are pointed like. /-\ ...as soon as I put it drive and move forward I feel a very slight pop then everything looks straight again.. what would that be?
Tighten the radius arms, and drop brackets?
Check that your tie rods are seated and tight, no wiggles?
Sound's like a loose tie rod.