Push bar mod build
#44
Senior Member
Thread Starter
I finally mounted the push bar. Man is it a PITA trying to do it by yourself between holding it centering and measuring then drilling holes so i wedged it up with a 2-4. Its on just got to wire it. Wasnt too bad off center or bolting it down. Just to wire it. Antbody know how
#45
Senior Member
if your asking to wire the lights it can be as simple as running a couple wires and a swtich. if you want to get complicated you can throw a relay on and a fuse in. just make sure you have a good ground.
#46
It's a Canadian thing eh!
Use a Relay, the light are much brighter and the switch wont get hot on your dash board
This is the best I.M.O way to wire up lights
This is the best I.M.O way to wire up lights
#48
Senior Member
Thread Starter
Not sure how im gonna do it dad said it should have wires running into the cab to just a toggle switch he says you cant have them on the road i was hoping to hook it up to the high beames And shut off on the low but i know nothing about wiring and i dont want to short anything out
#49
Senior Member
to have it come on with the high beams just wire up the relay like shown above but instead of the wire to the switch have a wire from the high beam wire running to your headlights control the relay.