DarkNite

Im in the middle of swaping gears in my 1991 F150. Rear is done, working on the front. I have the drive shaft off case open to where I can sort of get in it. How the crap do I get the axles out? I see a "C" clamp pin holding the passanger side in but nothing for the drivers side.... Is their something that Im not doing. Seems like the Housing should seperate from the Axle Arm Assembly a little easier but maybe it will when I get the axles pulled.

So I guess Im asking how do I pull the axles in a 1991 F150 4x4 Front End with a Dana 44 IFS....

mitchalvin

You need to remove the drivers side stub axle from the housing. The passengers side stays with the third member until after you have it out.

DarkNite

Thank you, after about 2.5hrs of googling I FINALLY found some info on proper removal.