dr_bowtie

ok since some of us have Hi-Jacked another thread and posted some times lets all do it here for comparison sake...

to get everything equal post up year, engine size, Auto or Manual trany, Rear end gear ratio and tire size...this will give others something to compare too...

Now I dont need to know other things like anything other than the results...

Also in a manual trany it may help telling how you took off and shift RPM...and what gears you used....

I'll go first...(you can quote this post and use the format i have and just add your specs)

Year 1995
Engine 4.9L 300-6
Transmission 5-speed Manual
Rear Axle Ratio 3.08 open
Tires P235/75r/15 (factory size)
0-60 times 13.04 seconds

let the clutch out normally rolling on the gas as I let the clutch out..rolling on the gas 3/4 throttle shifting into 2nd at 20mph shifting into 3rd at 40mph aprox 3500rpm and running 3rd all the way....

I notice these trucks dont like to be floored from the take off and they run better rolling in the throttle about 1/2 to 3/4 from a dead stop and then flooring once the RPMs are up....I made my pass close to floored but it wasnt...prolly just passed 3/4 throttle

now I am 100% sure I can get this into the 12 second range by launching harder...to the point of almost spinning the tire...I was at idle and rolling the throttle and clutch at the same time...I didnt bring up the RPM any at all....there you go...

EDIT: Other Mods...E-Fans and 160 T-Stat...Timing set at base 16 degrees...High voltage MSD Street Fighter Coil and MSD 6A box...them plugs dont stand a chance..lol Brass terminal cap and rotor...Toe set 1/16 toe-in....Royal Purple engine oil 10w20, ATF in the tranny with 2 quarts Red Lucas....thats about it...

1992Ford4x4

1992
351w
auto
3.55
33s
bout 9 and a half

blade z51

1994 F150 XLT

• 5.0, A/T, 3.55 gears, XLT trim w/ 75K miles, good condition
• 14° advance timing
• new plugs at .055" gap
• new wires
• new cap
• new rotor
• seafoam

0~60: 13.52

'09 C6 6.2 lt. 6 spd, no mods (I know, I know, just to put things in perspective)

0~60: 4.2

91whitelariat

Year 1991
Engine 4.9L 300-6
Transmission auto
Rear Axle Ratio stock size...idk?
Tires P235/75r/15 (factory size)
0-60 times 13.26 seconds
No mods...bone stock

Just stomped on it from a dead stop and let the auto tranny do its job. If i would have shifted myself i could probably get under 13 though.

sixx23

Year 1989
Engine 5.0L 302
Transmission Automatic
Rear Axle Ratio Stock Gears (Whatever that is)
Tires 31 x 10.5
0-60 times 17-19 Seconds..

Lenn

Year 2002 Supercrew 4x4
Engine 4.6L
Transmission Auto
Rear Axle Ratio ??
Tires 265/70/R16
0-60 times 48.02.... minutes.


I know, I know... Its not the right year range, but I'd figure its worth it to add.

Fast_V8

Year 2002 SuperCab 4x2
Engine 4.2
Transmission Auto
Rear Axle Ratio 3.55
Tires 265/75/R16
0-60 times 9.2 seconds


Year 1992 SingleCab Longbed 4x4
Engine 302
Transmission Auto
Rear Axle Ratio 4:10
Tires 255/70/16
0-60 times 8.3 seconds


Year 2004 F150 Heritage 4x2 SingleCab
Engine 4.6L 2V 260HP
Transmission Auto
Rear Axle Ratio 3.55 Locked
Tires 235/70/R16
0-60 times Under 7.5 seconds

95stepside

Year 1995 supercab 4x4
Engine 5.8
Transmission Auto
Rear Axle Ratio 3.55
Tires 265/75/15
0-60 times all afternoon...

khasse

Year 1993 flareside
Engine 5.0
Transmission5 speed
Rear Axle Ratio 3.55 ls
Tires 235/75/15
0-60 times7.9
i took off right below 2000 rpm, took it up to 4000 and took 3rd rest of the way. i also beat my friends 2003 acura cl 0-60 the other day, which made me smile.

mustangGT90210

Year '91 longbed
Engine 4.9
Transmission E4OD
Rear Axle Ratio 3.08
Tires 235/75/15
Mods True duals, no cats, just 1 muffler per pipe.
0-60 times Right around 10 I think