lacho713

how did u get those lights in your dash and how much was it? if u don't mind me asking

they are CDT

They came with the front speakers that I bought, I just mounted them there, cut a hole and put them in.

you may have broken the foil trace that pweres the light....get a small peice of wire, and try runing power from another spot on the switch to the LED...you could also have a bad LED..... I get a 9V battery and hooked up a 9v plug to it, then test each LED with that before and after I install them.

Hey man... How far are you from Baytown? There is ALMOST a meet set up at Houston Raceway Park... Chime in.

just the blue ones...they are clear/white during the day, and blue or what ever color your lights in the cluster are at night.

My stock needles still glow and look about the same as before. My turn signals are the brightest light in the dash, but its not blinding at all.

ok, get the 95 model needles, get your stock needles and take the front and the back apart.....there will be the cap, needle, and the back. measure the pin on the back of the 90's needles and match it up with a drill bit about 1 or 2 sizes smaller. drill a hole in the center of the stock needle back (on the flat side......only go deep enough to push the needle of the 90's needle into it, if you go too far it'll be lose on the cluster pin and wont hold!!!) after the hole is drilled, then cut/grind the flat stuff off (to get more light to the needle) or just position the hole in the back, over the large clear spot in the 90's needle back, press together, then install onto your cluster

it might be i jsut took it to a stereo shop and said i want 12's and need a box. i know its fiberglass. any stereo shop should be able to fab you one.

www.allelectronics.com has a good selection of abs boxes and things, you could cut one up. They might have boards too. I had some in my toolbox from an old set of fog lights.