Love your truck man. Looks near perfect

Thanks junior The Carbon fiber is a vinyl that I got off eBay.. it came in a 2'x5' roll. Its real nice stuff.

I am not sure how it reads the data.. I know it plugs into the vehicle data port. and gets it from the PCM. I would think that if you have a programer then it should see that data.

hey i really like the red with carbon fiber interior, nice job. can you tell me were you got the carbon fiber trim?

do you know if the ecometer reads the programed configuration or the stock. i ask bc if it reads stock then it will be off and a waste of money but if it reads the reprogrammed one then it should be correct, so do you know which

I have programed my PCM for the tire size change. But every time I put my stock tires back on for the winter I need to reprogram.

im sure your wheels a off from your stock size, my concern is that the meter would read off bc of my 33s. I have a tuner so my dash reads correct but im not sure if my port would

The Ecometer seams to be very accurate. To install it I used a dremal tool to cut out the area where the coin holder was, I just took my time and trimmed away little at a time till it fit. Its in there as a press fit. No real mounting needed.

is that ecometer pretty accurate when you calculate it? and how hard was it to mount it?

Hey, did you have any problems with the fuel guage? For me it takes a good minute or two to even show any reading and it changes from full to half to three quarters all the time. Did you have anything like this happen?