How to replace the Stock radios lightbulb.
03-04-2014, 09:18 PM
#1
lost my Car again...
Thread Starter
How to replace the Stock radios lightbulb.
I was going to post this in the how to section but i guess your not allowed to post new ones there. well here goes!
tools needed
1X small flat head scredriver
1X new lightbulb
1X 8mm socket (size might vary)
1X ratchet rench
Step by step instructions.
1. remove radio from dash and disconnect wiring.
2. remove plastic back hanger
3. take a small flat head screwdriver and begin to pry on the side of the top access panel.
4. remove the top access panel by lifting up and out
5. twist the old bulb out
6. put new bulb in.
pretty simple i know but hey i hope it helps someone out there.
tools needed
1X small flat head scredriver
1X new lightbulb
1X 8mm socket (size might vary)
1X ratchet rench
Step by step instructions.
1. remove radio from dash and disconnect wiring.
2. remove plastic back hanger
3. take a small flat head screwdriver and begin to pry on the side of the top access panel.
4. remove the top access panel by lifting up and out
5. twist the old bulb out
6. put new bulb in.
pretty simple i know but hey i hope it helps someone out there.
03-12-2014, 11:09 AM
#2
Formerly "the_breeze"
Did you convert that light to red as well? If so I'd really like to get a stock radio with a CD player. I want to keep everything stock looking but I really like red accents and I'm tires of my Sony Xplod.
