Brandon587

http://www.glowshiftdirect.com/MaxTo...tUqhoCQsXw_wcB
This is the trans temp gauge Im planning on getting. I realize it wont fit in that pod I posted above. http://www.glowshiftdirect.com/MaxTo...tUqhoCQsXw_wcB

Southernblues

1990Betty

Does anyone know if the bucket seats with the center console that folds up to a third seat from 95 or 96 would fit in a 90? thinking about doing a swap

Candy Red F150 FX4

Do they make a single gauge pillar.

Has anyone ever tried to put a Tweeter in a gauge pillar. How does it look and work.

Candy Red F150 FX4

I found an Idea for Tweeter Pods. I will try to build these and see what they look like. I think these might work for Gauge Pods also.


http://www.diymobileaudio.com/forum/...eter-pods.html

Brandon587

So, does anyone know if the headliner will come out the doors on an extended cab? It looks like they may if I removed the front seats. Im not sure how much it will bend to get out the door. The door opening diagonal was about 4 ft 7 inches, and front to back looked to be about 4 ft 8 at the longest point, in the center. And what do you all think about vinyl for a headliner. I think grey vinyl would look good. An other ideas.

redknight1

i'm sure it would look good as long as the craftsmanship was well done

dixie460

It will come out but you'll have to damn near bend it in half to get it thru unless, like you said, you take the seats out first.

Next time I do it I'm just gonna pop the back window out. It takes all of a couple minutes... just reach in and push the glass out. Putting it back in takes longer but not too bad once you get things lined up.

Brandon587

Well, the idea is while im doing it, I wouldn't mind giving the interior a deep clean. Take the carpet and pressure wash it, and just clean every thing really well. So I wouldn't mind taking the seats out and kill two birds with one stone. just looked like a tight fit.

Brandon587

Bought my headliner material and adhesive